This are basic steps for setting up a moon bouncer, there are many other ways to do this, but we found this to most effective way of operating the bouncer unit. Before setting up your bouncer, make sure you have access to nearest electrical outlet and TEST IT before you start.

Always inspect you unit before deflating it. Check the outside and inside for any damage and stains or dirt. It is a good practice to clean unit while you inspecting it, Use your broom to Sweep debris out the vent holes in the corners of the unit. Using a handheld vacuum clean out hard to reach corners and crevices.

Turn off the blower and unhook the both tube straps. After unit totally deflated, take out the stakes from ground and unhook them. if you were using sand bags unhook sandbags and pack them up, if you tied unit to the tree or another object untie them.

Inflatable units are rolled just like a sleeping bags. Always start rolling from the front of the unit, to move any remaining air toward the blower tubes. Start by grasping the end tightly then fold it in, keep pushing and flattening the roll as you go. It helps to have someone walk on the roll right in front of you.